AccuGolf Software Update – Version 1.0.53

Patch Notes:

1. GSPRO TCP PORT SETTING (NEW IN V1.0.53)
- AG Setting has a new TCP Port option with two choices:
  921 (Open API port) and 13392 (Accugolf Port). The default is 921.
- The selected port is saved as a number in device_config.xml, for
  example 921. RESET returns to 921.
- AccuGolf uses this port only for the GSPro connection. E6 (2483) and
  TGC (3344) continue to use their fixed ports.
- Existing configurations without tcpPortNumber keep working: AccuGolf
  and AG Setting both use 921, the previous GSPro port. AG Setting
  writes the field the next time SAVE is pressed. AccuGolf does not
  modify an existing configuration file.
- Invalid port values fall back to 921, and AccuGolf logs a [CONFIG]
  warning.
- AccuGolf reads the port once at startup. Restart AccuGolf after
  changing the port in AG Setting.
- The log shows the port in use:
  [SIMULATOR] connecting to GPRO 127.0.0.1:

2. GSPRO CONNECT RECONNECT (NEW IN V1.0.53)
- GSPro Connect can close the launch monitor connection while GSPro is
  still running, for example on the first shot after GSPro starts.
  AccuGolf now reconnects instead of closing.
- The first reconnect attempt starts after 1 second, then every
  2 seconds. If GSPro Connect is still unavailable after about
  15 seconds, AccuGolf exits.
- Shot data sent while the connection is down is not queued or resent.
  It is dropped and logged, so that shot does not reach GSPro.
- Connect, disconnect, reconnect, dropped data and exit after the
  15-second limit are logged with the [GSPRO] tag.

3. FRAME SYNCHRONIZATION AND FALSE-BALL FIXES (CARRIED FORWARD FROM V1.0.52)
- Fixed incorrect frame shifts caused by the fast bright-region detector
  selecting a reflection on the club instead of the actual ball.
  Both camera paths now use YOLO ball detections for synchronization,
  candidate selection and verification after a shift.
- Reject ball detection boxes fully contained inside a detected club
  box. Separate balls and partially overlapping ball boxes remain usable.
  This also prevents the observed club reflection from being selected
  as the final ball measurement after the real ball leaves the image.
- Shift candidates must satisfy the existing Y-alignment tolerance.
  Removed unverified fallback shifts and corrected candidate indexing
  when the reference pair occurs after the first captured frame.
- Check the actual resulting pair after applying a shift. If detection
  or alignment fails, restore the previous slave-frame sequence and log
  the failure instead of reporting synchronization success.
- Recalculate alignment after automatic Y-offset updates so a result
  obtained with the old offset cannot validate the updated coordinates.
- Log rejected reflections, candidate scores, accepted shifts, rollback
  and unverified matches, plus the first/last measurement residuals.
- Shot, spin and calibration formulas, simulator payload formats and the
  synchronized slow-putt endpoint search are unchanged by this sync fix.

The Software Update Section is exclusively for existing customers who are updating their sensors. If you're a new customer setting up your AccuGOLF system for the first time, please refer to the Installation Manual from the installation manual section to ensure a complete and correct setup. Using only the update files may result in an incomplete installation.

Version 1.0.53

Installation Manuals For Software Updates

How to Uninstall Spinview Manual

AccuGolf Software Update Manual